...
Test steps
1. Config IxNetwork with one switch and two hosts. Set the packet_in messages of the switch, the interval is 50ms, total 1000000 packets, using ICMP or ARP packets.
2. Start the controller with the features install.
3. Start the OF protocol of the switch.
4. Wait until the channel is established and Echo message interaction started.
5. Start the capture of IxNetwork.
6. Enable packet_in, wait until all of the packet_in messages are sent and no packet_out messages receive.
7. Stop the capture, analyse the messages captured. First verify the number of packet_out message N, N should be equal to 1 million, if N is less than 1 million, restart this test with smaller packet_in rate. Second, calculate the time difference between the first packet_out message and the last packet_out message T, the packet_out rate can be calculated by N/T. Third, calculate the time delay of each packet_in-packet_out pair as t1、t2、t3 ... ... , of course this can be caculate by decentralized way(select ten sets of pairs), at last calculate the latency by t1+t2+t3 ... ... /N.
8. Clean the configuration of controllers and IxNetwork.
9. Repeat test step 1-9 for five times.
10. Restart the test with another packet_in rate.
Test Results
IxNetwork current packet_in rate is only up to 30000 p/s, can not measure the maximum packet_in processing rate of controller. Therefore, we use BII test suite tested results to show.
Packet_out rate and latency
Packet_in rate (p/s) Packet_out rate (p/s) Latency(ms) 5000 5002 1.13 10000 10010 0.6 15000 14999 1.06 20000 19945 2.49 25000 24968 0.84 30000 29876 1.73 35000 34853 3.56 40000 40260 6.62 45000 41425 89.88 50000 44123 159.55 55000 45825 227.57 60000 46168 331.21 65000 46558 451.97 70000 47024 540.5 75000 48766 590.97 80000 46436 754.88 85000 48437 810.88 90000 48586 901.75 95000 48232 Packet loss occurs 100000 45921 Packet loss occurs Histogram of Packet_out rate
- Histogram of Packet_out latency

