Due to a ransomware attack, the wiki was reverted to a July 2022 version. . We apologize for the lack of a more recent valid backup.
...
- 8.1 Comparing ONOS topology to MN topology - PASS
- 8.2 Hosts view is consistent across all ONOS nodes - PASS
- 8.3 Hosts information is correct - PASS
- 8.4 Host attachment points to the network - PASS
- 8.5 Clusters view is consistent across all ONOS nodes - PASS
- 8.6 There is only one SCC - PASS
- 8.7 Device information is correct - PASS
- 8.8 Links are correct - PASS
- 8.9 Checking ONOS nodes - PASS
Case 7: Running ONOS Constant State Tests -
...
FAIL
- 7.1 Check that each switch has a master - PASS
- 7.2 Read device roles from ONOS - PASS
- 7.3 Check for consistency in roles from each controller - PASS
- 7.4 Get the intents and compare across all nodes - PASS
- 7.5 Check for consistency in Intents from each controller - PASS
- 7.6 Compare current intents with intents before the failure - PASS
- 7.7 Get the OF Table entries and compare to before component failure - PASS FAIL
- Changes were found in the flow tables
- 7.8 Leadership Election is still functional - PASS
Case 4: Verify connectivity by sending traffic across Intents -
...
FAIL
Ping across added host intents to check functionality and check the state of the intent
- 4.1 Ping across added host intents - PASS FAIL
- Intents have not been installed correctly, pings failed.
- 4.2 Check Intent state - PASS
- 4.3 Check leadership of topics - PASS
- 4.4 Wait a minute then ping again - PASS FAIL
- Intents have not been installed correctly, pings failed.
Case 15: Check that Leadership Election is still functional - FAIL
...
- 8.1 Comparing ONOS topology to MN topology - PASS
- 8.2 Hosts view is consistent across all ONOS nodes - PASS
- 8.3 Hosts information is correct - PASS
- 8.4 Host attachment points to the network - PASS
- 8.5 Clusters view is consistent across all ONOS nodes - PASS
- 8.6 There is only one SCC - PASS
- 8.7 Device information is correct - PASS
- 8.8 Links are correct - PASS
- 8.9 Checking ONOS nodes - PASS
Case 7: Running ONOS Constant State Tests -
...
FAIL
- 7.1 Check that each switch has a master - PASS
- 7.2 Read device roles from ONOS - PASS
- 7.3 Check for consistency in roles from each controller - PASS
- 7.4 Get the intents and compare across all nodes - PASS
- 7.5 Check for consistency in Intents from each controller - PASS
- 7.6 Compare current intents with intents before the failure - PASS
- 7.7 Get the OF Table entries and compare to before component failure - PASS FAIL
- Changes were found in the flow tables
- 7.8 7.8 Leadership Election is still functional - PASS
Case 4: Verify connectivity by sending traffic across Intents -
...
FAIL
Ping across added host intents to check functionality and check the state of the intent
- 4.1 Ping across added host intents - PASS FAIL
- Intents have not been installed correctly, pings failed.
- 4.2 Check Intent state - PASS
- 4.3 Check leadership of topics - PASS
- 4.4 Wait a minute then ping again - PASS FAIL
- Intents have not been installed correctly, pings failed.
Case 15: Check that Leadership Election is still functional - FAIL
...
- 15.1 Run for election on each node - PASS
- 15.2 Check that each node shows the same leader and candidates - PASS
- 15.3 Find current leader and withdraw - PASS
- 15.4 Check that a new node was elected leader - FAIL
- Something went wrong with Leadership election
- PASS
- 15.5 Check that that new leader was the candidate of old leader - FAIL
- Incorrect Candidate Elected
- 15.6 Run for election on old leader( just so everyone is in the hat ) - PASS
- 15.7 Check that oldLeader is a candidate, and leader if only 1 node - PASS
...
- 8.1 Comparing ONOS topology to MN topology - PASS
- 8.2 Hosts view is consistent across all ONOS nodes - PASS
- 8.3 Hosts information is correct - PASS
- 8.4 Host attachment points to the network - PASS
- 8.5 Clusters view is consistent across all ONOS nodes - PASS
- 8.6 There is only one SCC - PASS
- 8.7 Device information is correct - PASS
- 8.8 Links are correct - PASS
- 8.9 Checking ONOS nodes - PASS
Case 4: Verify connectivity by sending traffic across Intents -
...
FAIL
Ping across added host intents to check functionality and check the state of the intent
- 4.1 Ping across added host intents - PASS FAIL
- Intents have not been installed correctly, pings failed.
- 4.2 Check Intent state - PASS
- 4.3 Check leadership of topics - PASS
- 4.4 Wait a minute then ping again - PASS FAIL
- Intents have not been installed correctly, pings failed.
Case 10: Restore a link to ensure that Link Discovery is working properly - PASS
...
- 8.1 Comparing ONOS topology to MN topology - PASS
- 8.2 Hosts view is consistent across all ONOS nodes - PASS
- 8.3 Hosts information is correct - PASS
- 8.4 Host attachment points to the network - PASS
- 8.5 Clusters view is consistent across all ONOS nodes - PASS
- 8.6 There is only one SCC - PASS
- 8.7 Device information is correct - PASS
- 8.8 Links are correct - PASS
- 8.9 Checking ONOS nodes - PASS
Case 4: Verify connectivity by sending traffic across Intents - PASS
Ping across added host intents to check functionality and check the state of the intent
...
- 8.1 Comparing ONOS topology to MN topology - PASS
- 8.2 Hosts view is consistent across all ONOS nodes - PASS
- 8.3 Hosts information is correct - PASS
- 8.4 Host attachment points to the network - PASS
- 8.5 Clusters view is consistent across all ONOS nodes - PASS
- 8.6 There is only one SCC - PASS
- 8.7 Device information is correct - PASS
- 8.8 Links are correct - PASS
- 8.9 Checking ONOS nodes - PASS
Case 4: Verify connectivity by sending traffic across Intents - PASS
Ping across added host intents to check functionality and check the state of the intent
...
- 8.1 Comparing ONOS topology to MN topology - PASS
- 8.2 Hosts view is consistent across all ONOS nodes - PASS
- 8.3 Hosts information is correct - PASS
- 8.4 Host attachment points to the network - PASS
- 8.5 Clusters view is consistent across all ONOS nodes - PASS
- 8.6 There is only one SCC - PASS
- 8.7 Device information is correct - PASS
- 8.8 Links are correct - PASS
- 8.9 Checking ONOS nodes - PASS
Case 4: Verify connectivity by sending traffic across Intents - PASS
Ping across added host intents to check functionality and check the state of the intent
...