Due to a ransomware attack, the wiki was reverted to a July 2022 version. . We apologize for the lack of a more recent valid backup.
...
Code Block |
---|
onos> devices id=of:00000000000000a1, available=true, role=MASTER, type=SWITCH, mfr=Nicira, Inc., hw=Open vSwitch, sw=2.3.0, serial=None, protocol=OF_1310 id=of:00000000000000a2, available=true, role=MASTER, type=SWITCH, mfr=Nicira, Inc., hw=Open vSwitch, sw=2.3.0, serial=None, protocol=OF_1310 id=of:00000000000000a3, available=true, role=MASTER, type=SWITCH, mfr=Nicira, Inc., hw=Open vSwitch, sw=2.3.0, serial=None, protocol=OF_1310 id=of:00000000000000a4, available=true, role=MASTER, type=SWITCH, mfr=Nicira, Inc., hw=Open vSwitch, sw=2.3.0, serial=None, protocol=OF_1310 id=of:00000000000000a5, available=true, role=MASTER, type=SWITCH, mfr=Nicira, Inc., hw=Open vSwitch, sw=2.3.0, serial=None, protocol=OF_1310 id=of:00000000000000a6, available=true, role=MASTER, type=SWITCH, mfr=Nicira, Inc., hw=Open vSwitch, sw=2.3.0, serial=None, protocol=OF_1310 |
Running SDN-IP for the first time
...
First, from the Mininet CLI we can start up an xterm so we can connect to the Quagga CLI.
Code Block |
---|
mininet> xtermr4 lxterminal r4& |
A little xterm new terminal window will pop up which gives us a terminal on the r4 router node. The next few commands will by typed into this xterm window.window - pay attention to the command prompt to ensure you're typing commands into the correct place.
We can use telnet to connect to the Quagga BGP CLI.
Code Block |
---|
root@ubunturoot@mininet-vm:~# telnet localhost 2605 Trying 127.0.0.1... Connected to localhost. Escape character is '^]'. Hello, this is Quagga (version 0.99.23). Copyright 1996-2005 Kunihiro Ishiguro, et al. User Access Verification Password: |
...