Page tree

This is an archive of the ONOS 1.0 wiki. For the current ONOS wiki, look here.

Skip to end of metadata
Go to start of metadata
  1. Configure CAM

    #configure
    (conf)#cam-acl l2acl 2 ipv4acl 2 ipv6acl 0 ipv4qos 0 l2qos 1 l2pt 0 ipmacacl 0 vman-qos 0 ecfmacl 0 openflow 8
    (conf)#cam-acl-vlan vlanopenflow 1 vlaniscsi 1  vlanaclopt 0
    (conf)#exit
  2. Reboot the switch

    #reload
    System configuration has been modified. Save? [yes/no]: yes
    !
    
    Proceed with reload [confirm yes/no]: yes
  3. Create openflow instance

    #configure
    (conf)#openflow of-instance 1
    (conf-of-instance-1)#controller 1 10.11.44.5 tcp [ change to your controller ip ]
    (conf-of-instance-1)#flow-map l2 enable
    (conf-of-instance-1)#flow-map l3 enable
    (conf-of-instance-1)#interface-type any
    (conf-of-instance-1)#multiple-fwd-table enable
    (conf-of-instance-1)#of-version 1.3
    (conf)#exit
  4. Add interfaces to the openflow instance

    (conf)#interface TenGigabitEthernet 0/0 [ change to your network ports]
    (conf-if-te-0/0)#of-instance 1
    (conf-if-te-0/0)#no switch-port
    (conf-if-te-0/0)#no shutdown
    (conf)#exit
  5. Enable the openflow instance

    (conf)#openflow of-instance 1
    (conf-of-instance-1)#no shutdown
    (conf-of-instance-1)#exit
  6. Ensure that the network configuration file loaded on to the controller matches the configuration of the hardware.

  • No labels