FUNCflow at 07 Jan 2016 19:59:06
Case 1: Constructing test variables and building ONOS package - PASS
- 1.1 Constructing test variables - PASS
Case 2: Starting up 1 node(s) ONOS cluster - PASS
- 2.1 Apply cell to environment - PASS
- 2.2 Creating ONOS package - PASS
- 2.3 Uninstalling ONOS package - PASS
- 2.4 Installing ONOS package - PASS
- 2.5 Starting ONOS service - PASS
- 2.6 Start ONOS cli - PASS
Case 10: Setup mininet and compare ONOS topology view to Mininet topology - PASS
Start mininet with custom topology and compare topology elements between Mininet and ONOS
- 10.1 Setup Mininet Topology - PASS
- 10.2 Assign switch to controller - PASS
- 10.3 Comparing MN topology to ONOS topology - PASS
Case 1000: Verify flow MAC selectors are correctly compiled - PASS
Install two flows with only MAC selectors specified, then verify flows are added in ONOS, finally send a packet that only specifies the MAC src and dst.
- 1000.1 Add flows with MAC addresses as the only selectors - PASS
- 1000.2 Check flows are in the ADDED state - PASS
- 1000.3 Check flows are in Mininet's flow table - PASS
- 1000.4 Send a packet to verify the flows are correct - PASS
Case 2000: Delete flows that were added through rest - PASS
- 2000.1 Deleting flows - PASS